Definity support dcs, and Uniform dialing plan, so you just dial, say 4-digit to reach extensions on other PBX. Can I do this between two PBX, one is, say Definity and another is NEC. Can I trunking these two PBXs using Q.Sig supported by cisco routers or switches. If yes, what kind of trunk card do I need for both PBXs?.............
Re: conneting Definity to NEC PBX over Cisco clould?
Typically the best way to tie two PBX's together is by using T-1 (DS-1) cards in each PBX and connecting them to channelized T-1 VWIC's in the routers. You can also use E&M Tie Trunk cards in the PBX's and E&M VIC's in the router. As far as QSIG, the Definity will support it but you check with your NEC vendor to make sure the model of NEC you have will suppport it and to what level. Some only support basic QSIG and not supplementary services.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.