Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CRA Database Subsystem : Using MS Access

For a demo, i was trying to configure a MS Access datasource in IPIVR to do a DB Lookup from the IVR script. The IVR Engine wouldnt recognize the datasource.

Has anyone tried using a datasource for a MS Access database ?

Kamesh

1 REPLY
Bronze

Re: CRA Database Subsystem : Using MS Access

The following link says this: "Before you can successfully use DB Lookup in a script, information about the table to be queried must be defined in Configure ICM".

http://www.cisco.com/univercd/cc/td/doc/product/icm/icm45/script45/se45_aa.htm#xtocid14

113
Views
0
Helpful
1
Replies
CreatePlease to create content