We have installed CRS 3.0 over a beta 3.0. Upon accessing the web interface for the initial Application Manager logon, the startup password is not working (Administrator - ciscocisco). We've tried the existing password (as defined using the beta code) however, this also fails. Have also tried to change the Call Manager/ DC Pwd and initiate the reg hacks for the encrypted password (using c:\dcdsrvr\bin\passwordutils.exe) however, this also proved unsuccesfull.
As we stand, we cannot logon to the initial, def. password to the Application Administrator for CRS 3.0. Currently, we are attempting a re-install. If this fails, we may be forced to wipe the box and all it's configs (not much, but, some nonetheless) and begin with a clean load.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...