Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CRS 3.x and CallManager 3.3(3)sr4a

I have a problem where the CRS engine wont start after a system reboot. I can go into service manager and start it manually and it works fine. The service is set to start automatically. And it was doing the same thing when callmanager was at sr3. The CRS is co-resident on a subscriber callmanager.

1 REPLY
Blue

Re: CRS 3.x and CallManager 3.3(3)sr4a

The CRS server will not really fully come up until the CTI Manager service on CallManager is up. I suspect maybe your CTI Manager service on CallManager is maybe hanging, or your CRS services aren't waiting. I would open a TAC case, or make a batch file that fires up CRS after CM is up.

80
Views
0
Helpful
1
Replies