have 3 powerware 9125 UPS with a network interface, installed the netwatch client on 2 callmanagers, unity and paging server. the paging server works fine, but the other 3 start the shutdown (testing)but then the netwatch service stops due to CSA stopping it. When I installed the netwatch CSA prompted for installation and replied always.
log in CSA is attached (July 12 has 4 entires, this is the time period)
not sure how the configure this headless agent to accept the process Netwatch is trying to use to shut the server down (when battery threshold has been reached).
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...