I am currently trying to assist an installation of a third party call center software called Apropos. This will connect to our are Call Manager running 3.3(2). We basically set up 10 Cti route points and created a user with the devices under it. Apropos can control the phones it has under it but when we try and call the route point it just goes down the hunt group and then gives us a fast busy. It looks like it might be an issue with the CTI routing. We our not sure if it is on the call manager side or the Apropos side. Apropos system does show the call coming in but thats it.I have looked into the trace logs in our call manager and this is what I see:
CTI Trace log:
10/28/2003 11:31:32.242 CTI|kCtiProviderOpenFailure - CTI application failed to open provider CTIconnectionId:64 Login User Id:ac UNKNOWN_PARAMNAME:ReasonCode:2362179680 IPAddress:192.168.10.4 App ID:Cisco CTIManager Cluster ID:StandAloneCluster Node ID:C3ICM1|<CLID::StandAloneCluster><NID::C3ICM1><CT::Alarm>
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...