CUAE after install I Can not access to mceadmin web page
I install all prerequisites. I follow step by step and the exact versions and in the order the document "Prerequisites for Installation of the Cisco Unified Application Enviroment" specify. I have no problem with this.
then I install:
1) Platform Services
2) Cisco Unified Application Server
3) Cisco Unified Media Engine
In that order. I did not receive any warnings or error in the installation process.
All the prerequisites and products were installed in the same server using VMWare (XP Professional SP2 RAM 1.5GB) via VNC (not Remote Desktop).
After that, follow the "Cisco Unified Application Enviroment Administration Guide" manual. I try to access to:
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...