I need to install a CUBE IP_IP GW H323 to H323 on a client network that has an mpls connection to an ATT IPGW. There is no Gatekeeper involved. I need help coming up with a config to do this, I have no experience with CUBE. From what I can tell, I need to have dial-peers but the Cisco Docs just confuse me as to what I really need in the config for CUBE. I will be sending calls from CM to CUBE and CUBE will route the calls to the mpls router. Please Help!! Thx!
Some more details, The client is currently using a NAT router to connect calls to the provider. We wnat to replace the nat router with a cube that is setup as an H323 Gateway in CM, route calls to it and send the calls to the MPLS router out to the ATT IPGW.
are you just trying to do this to bridge the 2 different networks? I do the same thing essentailly with SIP to H323 for my home! it should be very easy, clearly defined inbound and outbound dial peers on the gateways. And enable CUBE..
Hi, I'm doing H323 to H323, no SIP involved, I hope to be able to start testing with this next week. I know there is more needed, interfaces need to be configured and binded and that is not clear to me.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...