Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CUCM 6.1 MGPC gateways 2 codecs

We have a scenario where we need to implement g729 between two gateways ( 1 local & 1 remote ) Connected to the local gateway is a ACD which sends calls via E1 TDM trunks but is completely random as to which trunk it uses, it sends all calls in this direction ( via a pool of steer codes we use ) to be more specifically routed by CUCM to the relevant endpoint ( all MGCP gateways ). To be handed off to vendor TDM infrastructure.

In this instance we wish to move 1 vendor on g729. Is there any way of doing this as we cant force the ACD to use a specific port and therefore onto a port with the correct device pool configured ??

1 REPLY
Anonymous
N/A

Re: CUCM 6.1 MGPC gateways 2 codecs

To which codec you are trying to change?

95
Views
0
Helpful
1
Replies