11-21-2008 08:35 AM - edited 03-13-2019 05:52 PM
Hello,
I have been looking for some data sheets on Cisco.com in regards to upgrading a existing CCM 4.2(3) to CUCM 7. Specifically I'm looking to find out if the IBM x346 series server will support CUCM 7.
Anyone know?
I have found this link but it doesn't state if it supports version 7.
Regards,
Justin
Solved! Go to Solution.
11-21-2008 08:48 AM
Hi Justin,
Have a look at Table 3 in this good doc :)
Cisco Unified Communications Manager Server Support Matrix
Hope this helps!
Rob
11-21-2008 08:48 AM
Hi Justin,
Have a look at Table 3 in this good doc :)
Cisco Unified Communications Manager Server Support Matrix
Hope this helps!
Rob
11-21-2008 08:53 AM
RRR I was so close and missed that doc..... Thanks Rob... ;) This is exactly what I was looking for...
11-21-2008 10:48 AM
Hi Justin,
You are most welcome! In the 80 Zillion docs here it's hard to find the one you want sometimes.
Cheers!
Rob
11-24-2008 03:59 PM
Hi Rob,
The IBM xSeries 346 that I'm trying to see if supports CUCM 7 is not listed as the server contains a 2.8 ghz intel xeon processor
My server specs:
IBM x346
Intel Xeon 2.8 ghz processor
2 x 70gb HD
2Gb RAM
Any idea's?
11-25-2008 06:24 AM
Hi Justin,
You do seem to meet the minimum spec's for a CCM 7.0(1) build;
Cisco Unified CM requires a minimum of 2 GB of memory, 72 GB disk drive, and 2 GHz processor.
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/rel_notes/7_0_1/cucm-rel_notes-701.html#wp579941
But, I would be hesitant to proceed without verification from TAC that this will be a supported install. You might also want to engage your Cisco SE to do some research here as well.
Hope this helps!
Rob
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: