Looking for some best practice/offical advise for the follwing solution.
We are looking to deploy TX 9000 endpoints on CUCM 10.x.
However the majority of the current enviroment is still in a 'Tandberg' style deployment relying on TMS, VCS, etc. We have a range of endpoints across a number of different business groups (C, SX, MX, EX). We are looking to migrate a number of these endpoints along with the TX systems onto the CUCM.
My Question is, what is the best practice for sharing address books across these two enviroments. I have looked through all the Cisco documentation I can find, and have read on the forums the extensive discussions, about TMS shared address books with CUCM and provisiong address book issues with older systems. So was looking for any advice or pointers to where I can find what solution for this I should deploy.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...