Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CUCM6 and 881SRST

I've been looking over the docs and it looks like the 881 ISR is currently only supported on CUCM7.

Has anyone configured the FXO port for use on another version of CUCM? If so how did you so so?

Thanks,

Aaron

5 REPLIES
Cisco Employee

Re: CUCM6 and 881SRST

you can use H323 independently of CUCM version as long as the IOS has voice capabilities so you can configure the dial-peers

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: CUCM6 and 881SRST

Java-

Thanks for the assistance. I'm was looking through the guides for H323 and configuring the gateway, and fxo,fxs ports.

I'm looking on the site for configuration examples.

Cisco Employee

Re: CUCM6 and 881SRST

there are plenty of examples, hard to believe you didn't run into one

Cisco IOS H.323 Gateway Configuration for Use with Cisco CallManager

http://www.cisco.com/en/US/partner/products/sw/voicesw/ps556/products_tech_note09186a0080094636.shtml

Cisco IOS H.323 Configuration Guide, Release 12.4T

http://www.cisco.com/en/US/docs/ios/voice/h323/configuration/guide/12_4t/vh_12_4t_book.html

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: CUCM6 and 881SRST

Sorry I never updated the thread. I did find plenty of examples it was just the matter of getting the right config together to use the FXO/FXS ports.

There are still some issues I'm working out with the FXS port saying its on-hook but not generating dial tone on the FXS port after it received a call that came inbound in the FXO port.

Aaron

New Member

Re: CUCM6 and 881SRST

I have a simple question, the 881SRTS router can be register with a CUCM 7 and work has a remote gateway (SCCP,MGCP or H323) with FXO lines ?

653
Views
13
Helpful
5
Replies