Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CUCME 4.0 and Video

Dear all,

1. I want to organize SCCP 2 SCCP video call between to IP Phones:

- CUCME 4.0(0)

- IP Phone 7941 SCCP-based (load file is SCCP41.8-3-3S)

- IP Phone 7961 SCCP-based (load file is SCCP41.8-3-3S)

- All are living in the same subnet

2. I've configured:

- 'video' under each ephone (enables IP Phone video support)

- 'video > maximum bit-rate 256' under telephony-service mode

- 'service phone videoCapability 1' under telephony-service mode

- said 'create cnf-files', resetted the phones

3. 'show ephone registered'

ephone-3 Mac:0017.E041.ABCD TCP socket:[1] activeLine:0 REGISTERED in SCCP ver 12 and Server in ver 5

mediaActive:0 offhook:0 ringing:0 reset:0 reset_sent:0 paging 0 debug:0 caps:8

IP:A.B.C.D 52840 7941 keepalive 0 max_line 2

button 1: dn 3 number 511 CH1 IDLE CH2 IDLE

Username: AAA Password: BBB

Do my phones can video ?

1 REPLY
Blue

Re: CUCME 4.0 and Video

Your phones cannot do video without the proper VTA pieces set as well as your 7941/61s configured to do video.

You've got the 7941/61 video configuration so now all you need is to setup some VTA hardware/software at the users workstations.

Please see the following link for VTA config on CME:

http://www.cisco.com/en/US/products/sw/voicesw/ps5662/products_configuration_example09186a0080725c15.shtml

124
Views
5
Helpful
1
Replies
CreatePlease to create content