Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

cue aa unknown number

is it possible to test the aa from an extension?

the def aa was enabled but it shows unknown number when i dial the number from one of the extension.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: cue aa unknown number

The CUE AA receives call from the CME via a SIP dial peer. So as long as you have a dial peer that points to the IP address of the CUE , it should be reachable from POTS legs , IP legs (if you have 'voice service voip'/'allow connections ...' configured) and ephone call legs.

The dial peer should be something like this -

!

dial-peer voice 10 voip

description - calls to AA application on the CUE

destination-pattern 5000

session target ipv4:10.1.1.1 <---Ip address of CUE

session protocol sipv2

codec g711ulaw

dtmf-relay sip-notify

!

The CUE will need to have a relevant config as well - you can enable the aa application from the GUI or from the CUE cli. All it needs is a trigger number that matches what you have configured under the SIP dial peer on the CME.

Otherwise paste the configs of the CME and CUE here so we can have a look at it.

3 REPLIES
Cisco Employee

Re: cue aa unknown number

The CUE AA receives call from the CME via a SIP dial peer. So as long as you have a dial peer that points to the IP address of the CUE , it should be reachable from POTS legs , IP legs (if you have 'voice service voip'/'allow connections ...' configured) and ephone call legs.

The dial peer should be something like this -

!

dial-peer voice 10 voip

description - calls to AA application on the CUE

destination-pattern 5000

session target ipv4:10.1.1.1 <---Ip address of CUE

session protocol sipv2

codec g711ulaw

dtmf-relay sip-notify

!

The CUE will need to have a relevant config as well - you can enable the aa application from the GUI or from the CUE cli. All it needs is a trigger number that matches what you have configured under the SIP dial peer on the CME.

Otherwise paste the configs of the CME and CUE here so we can have a look at it.

New Member

Re: cue aa unknown number

thats great...thanks man

New Member
226
Views
0
Helpful
3
Replies