07-13-2006 06:47 PM - edited 03-13-2019 02:11 PM
I have CUE 2.1.3 on 2821 router, which was working fine until I upgraded the IOS of the router to 12.4 and upgraded the CME to 3.3.
I can not ping the service-module from anywhere except the router, thus I cannot connect to the web GUI. I've tried using unnumbered IP as well as an IP address. I can ping the service-engine IP fine, any clues?
Chris
07-13-2006 07:32 PM
Have you set a default route for the ip address of the service-engine ?
if CME is 10.1.11.4 and service engine has ip address 10.1.11.5 which is entered using command,
int s0/0
service-module ip address 10.1.11.5 255.255.255.0
service-module ip default-gateway 10.1.11.4
you also need a static route to 10.1.11.5 as follows.
ip route 10.1.11.5 255.255.255.255 service-engine0/0
Is this route in place ?
07-13-2006 07:36 PM
I have default route, the static route is only required when unnumberd IP is used.
What is the Ethernet port on the NM-CUE used for, I have nover plugged it in, is it necessary?
Chris
07-13-2006 08:14 PM
That interface is disabled. Check this link
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: