Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Hall of Fame Super Silver

CUE connectivity issues

I have CUE 2.1.3 on 2821 router, which was working fine until I upgraded the IOS of the router to 12.4 and upgraded the CME to 3.3.

I can not ping the service-module from anywhere except the router, thus I cannot connect to the web GUI. I've tried using unnumbered IP as well as an IP address. I can ping the service-engine IP fine, any clues?

Chris

3 REPLIES

Re: CUE connectivity issues

Have you set a default route for the ip address of the service-engine ?

if CME is 10.1.11.4 and service engine has ip address 10.1.11.5 which is entered using command,

int s0/0

service-module ip address 10.1.11.5 255.255.255.0

service-module ip default-gateway 10.1.11.4

you also need a static route to 10.1.11.5 as follows.

ip route 10.1.11.5 255.255.255.255 service-engine0/0

Is this route in place ?

Hall of Fame Super Silver

Re: CUE connectivity issues

I have default route, the static route is only required when unnumberd IP is used.

What is the Ethernet port on the NM-CUE used for, I have nover plugged it in, is it necessary?

Chris

Re: CUE connectivity issues

133
Views
0
Helpful
3
Replies