Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CUE H323 WAN

Hi,

got the following setup:

ip phone (CCM - Site A) to remote site B using cme/cue

Local site can use cue correctly.

Calls from A to B work fine but when the calls is forwarded to CUE user on site A is connected but hears nothing.

Version CME: 4.0

Version CUE: 2.1

Codec g77ulaw

Voicemail pilot is 7000

Config of CME router:

voice service voip

allow-connections h323 to h323

allow-connections h323 to sip

allow-connections sip to h323

allow-connections sip to sip

telephony-service

load 7960-7940 P0030702T023

max-ephones 20

max-dn 40

ip source-address 10.76.1.254 port 2000

sdspfarm units 4

sdspfarm transcode sessions 4

sdspfarm tag 1 mtp00152bc44b5c

time-format 24

date-format dd-mm-yy

voicemail 7000

max-conferences 2 gain -6

call-forward pattern .T

dn-webedit

transfer-system full-blind

secondary-dialtone 9

dial-peer voice 702 voip

destination-pattern 7000

session protocol sipv2

session target ipv4:10.76.1.250

dtmf-relay sip-notify

codec g711ulaw

no vad

Thankd for your help,

Fred

1 REPLY
Silver

Re: CUE H323 WAN

This type of network contains only Cisco CME 3.1 or later systems and Cisco CallManager systems. The Cisco CME 3.1 or later release supports automatic detection of calls to and from Cisco CallManager using proprietary signaling elements that are included with the standard H.323 message exchanges. Refer URL

http://www.cisco.com/univercd/cc/td/doc/product/voice/its/cme33/cme33sa/cme33bsc.htm#wp1005261

139
Views
0
Helpful
1
Replies
CreatePlease to create content