I have an issue with a license I got from cisco I made a mistake during downloading it instead of writing the PID and SERIAL NUMBER for the AIM-CUE modue I write that of the router So when try to installit for unity it give me the following error
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.