Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CUE telnet

Hi All;

when I telnet to CME and then try ro connect to CUE by: "service-module service-engine 0/0 session" , I receive error message: "connection is refused by remote host" . How should I fix that problem?

Thanks

Alex

4 REPLIES
New Member

Re: CUE telnet

Hi,

First verify that you may be able to ping to the IP addres of the ServiceEngine.

Another option is to clear line TTY XX.

It depends, maybe the telnet session is used by someone else, or another device didn't close its session.

You will see the number of the TTY because you wil receive this message

Trying A.B.C.D, 20XX...

%Connection refused by remote host

Just clear the line TTY XX

Hope it works.

Orlando.

New Member

Re: CUE telnet

The command is "clear line XX"

or "clear line tty XX"

Let me know if it works!

OM.

New Member

Re: CUE telnet

Thanks

It was very helpful. If I connect to CUE by console, I can't connect by telnet. first I have to clear session in console then connect by telnet.

Alex

New Member

Re: CUE telnet

Yes, or exit the telnet session, it will close the session.

Some times we close the session Ctrl+Shift+6 X, it depends some times it doesn't close the telnet session.

Please rate the post.

THanks

OM

712
Views
0
Helpful
4
Replies
CreatePlease to create content