I have an issue where a user's voice mailbox is showing as being in the busy status when I run the "show voicemail detail mailbox <username>" command. Does anyone know how to change the line state of the user using CLI.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.