Hello, I am trying to make a CUMA 7 work, for first time, I followed the installation guide but it doesn't seem to work. Everything is configured, but when I try to start it, it just doesn't. And I don't know how to troubleshoot it.
What I can see is that the CUMA server doesn't try to communicate with the ASA, since no traffic can be seen in the ASA log coming from the CUMA server.
Does anyone know where I can see the problem that is preventing the server to start?
Hi, just in case in the future someone hasthe same problem... The problem was solved entering the DNS IP address manually through CLI for the eth0 interface. A reboot was needed after that for it to work.
The CUMA server has to be able to resolve the ASA IP address even if it's not going to establish contact with it at the startup.
Where do you specifiy the ASA IP on the CUMA server? I see where you enter the Proxy Host Name. That is the outside FQDN CUMC devices use. Does that need to be mapped internally to the inside IP of the ASA or something?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...