Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

dbwalker error on Esubscriber

Getting ready to run DiRT on a 3.13 install, ran dbwalker, as suggested beforehand and get the following on the Example Subscriber:

(error) The primary call handler for this subscriber has it's AdministratorObjectID value set to point to a different subscriber.

You can fix this in DOHPropTest by copying the ObjectID of the subscriber into the AVP_ADMINISTRATOR_OBJECT_ID value for the primary call handler.

This can also, however, mean a there is a 'cross linked' call handler problem where a single primary call handler is being 'shared' by more than one subscriber.

Not sure how to proceed. Any thoughts?

  • Other Collaboration Voice and Video Subjects
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: dbwalker error on Esubscriber

If that's the only error you're getting, you're in good shape. That's a long standing known configuration error in the Unity setup (finally fixed in 4.0(1)). It's nothing to worry about, I'd just ignore it and press ahead. The same error will be in your new install you'll be restoring into anyway.

2 REPLIES
Cisco Employee

Re: dbwalker error on Esubscriber

If that's the only error you're getting, you're in good shape. That's a long standing known configuration error in the Unity setup (finally fixed in 4.0(1)). It's nothing to worry about, I'd just ignore it and press ahead. The same error will be in your new install you'll be restoring into anyway.

New Member

Re: dbwalker error on Esubscriber

Great, thanks Jeff.

85
Views
0
Helpful
2
Replies