Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Debug Outbound CAS Digits

Is there a debug that will show the digits that are being outpulsed on a CAS T-1? I am using an MGCP Gateway and I can see the digits that CCM is sending to the gateway using debug mgcp packets, but I wanted to verify that the digits are being outpulsed by the gateway correctly.

1 REPLY
Silver

Re: Debug Outbound CAS Digits

Try this debug command, I have used this on a AS5400 to see the digits on a T1 CAS.

debug sigsm digits

168
Views
0
Helpful
1
Replies
CreatePlease to create content