Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Definity G3r as Gateway for the CallManager

Hi@all,

i have configured the definity (Software Release 9) and the cisco callmanager like this: http://www1.avaya.com/enterprise/whitepapers/ip600cm2924.pdf !

The call from callmanager to definity works, but from definity to callmanger the call does't working. The Trunk give a fast busy.

Can this associate with the Software Release 9 from the definity?

Any ideas?

regards

Chris

1 REPLY
New Member

Re: Definity G3r as Gateway for the CallManager

Check your CSS on your Voice Gateway routers. I had a similar problem when trunking between our Meridian One and our CallManagers. Set a CSS that has all of the partitions that you need the Voice Gateway to be able to reach, then apply it to the gateway. If you are using MGCP, you will have to reset or restart the gateway (which sometime doesnt work, at least on a VG200). Sometimes I need to phsyically restart the router or issue a clear MGCP to accept the new settings. I am not sure if this is your problem, but I hope it helps.

Matt

94
Views
0
Helpful
1
Replies
CreatePlease to create content