I have updated my callmanager to 3.2(1) add I have added the service Path cisco callmanager 3-2-1-spB.
With the old version I use the octothorpe (#) key to signal the end of the dialing Sequence (( to signal that the last digit has been entered )) and my call has establishes immediately, without a delay of 15 Sec.
Now with the new version when I added the octothorpe (#) key I have always a busy tone.
Note : I dont want reduce the parameter interdigit timeout value (( in my callmanager TimerT302_msec = 15000 ))
Check in "Route Pattern Configuration" under "Called Party Transformations" and be sure the Discard Digits instructions include stripping the trailing-#. If this doesn't resolve the busy tone issue you may want to open a case with Cisco as this might be a software issue.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.