Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Delay in Starting RTP

Hi All,

We have an inter cluster trunk between CCM versions 3.3(3) and 4.1(2). Both the Callmanagers are located in same LAN.

If I make a call between clusters, the call setup is immediate. But after the handset is picked, no voice flow for 2 seconds. After 2 seconds, voice flow starts. No delay or jitter noticed later.

Any of you have noticed this kind of problem?

Regards,

Venkatesha Reddy

1 REPLY
Blue

Re: Delay in Starting RTP

I have seen this occur when Media Termination Point required was selected on the trunk configuration. It only seemed to happen with IOS MTP, 6608 MTP was OK.

129
Views
0
Helpful
1
Replies