Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Delay on trunk access dial-tone.

After dialing "8" for an outside access code, our system used to provide dial tone and wait for the rest of the string. As of last week, without any changes, the system now waits for the 8 + the next number before providing dial tone. Has anyone experienced this before? I am running CM 3.14b.

The second dial tone is set to come fromt eh route patterns and I have verified that the box is checked at teh route pattern. I have also tried to reset all the patterns to no avail.

any suggestions??

2 REPLIES
New Member

Re: Delay on trunk access dial-tone.

I only suspect that someone has added a dial pattern 8XXX or something like that. I'd check this out....

New Member

Re: Delay on trunk access dial-tone.

yup, pattern 800x was added to the meet-me conference at some point. I must have forgotten. Good catch, (sheepishly thankful)

j

96
Views
5
Helpful
2
Replies
CreatePlease to create content