Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Delete System Message after personal Announcment

I configure a personal Announcment, but after the this message always the default system announcment follows.

How can I delete this System message?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Delete System Message after personal Announcment

I assume you mean the "I'll record your message at the tone..." prompt that is tacked onto the end? If so, check out this thread for details on how to make that prompt not play any longer:

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&type=bookmarks&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40.ee83e4c/0#selected_message

Just be aware that process is not TAC supported and you'll have to redo it after an upgrade.

2 REPLIES
Cisco Employee

Re: Delete System Message after personal Announcment

I assume you mean the "I'll record your message at the tone..." prompt that is tacked onto the end? If so, check out this thread for details on how to make that prompt not play any longer:

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&type=bookmarks&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40.ee83e4c/0#selected_message

Just be aware that process is not TAC supported and you'll have to redo it after an upgrade.

New Member

Re: Delete System Message after personal Announcment

Hi

I make this changes and it works.

Thank you

87
Views
0
Helpful
2
Replies