when using the demo version, does selecting Cisco for the IP switch type utilize a port? In otherwords, does the demo version actually only make available 1 Unity port if the Cisco IP switch has been selected?<br><br>
strange things happening... to get the MWI to work, in the switch settings, I had to setup CM as a Serial connection. The first time I tried this and after rebooting, I was down to only having 1 available port for the system. I removed the Serial integration and after rebooting, my second port returned. I then again added the Serial connection in the switch settings and the MWI functionality returned and this time I had two active ports.
I'll add that to my troubleshooting notes under 'Unexplained'
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...