Is there a alternative command if you don't want to apply the destination pattern command under the dial-peer voip command. What command can be used instead to call an outbound number (voip) without using the destination pattern command.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...