Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our beta test area to get started.

New Member

destination-pattern with "*" and "#"

Hi Guys,

I need to create a dial-peer with destination pattern like this "*75....#".

All digits matched must be send, include "*" and "#".

Any clue?

thanks in advance

  • Other Collaboration Voice and Video Subjects
3 REPLIES

Re: destination-pattern with "*" and "#"

VOIP dial peers send all digits by default. POTS dial peer strip wild cards by default, so you could configure one of the following:

dial-peer voice 1 pots

destination-pattern *75....#

forward-digits all

or

dial-peer voice 2 voip

destination-pattern *75....#

Hope this helps. If so, please rate the post.

Brandon

New Member

Re: destination-pattern with "*" and "#"

HI,

My config is as follows:

dial-peer voice 70 pots

destination-pattern *75....#

port 1/1/0

forward-digits all

Even with forwards-digits all, it seems that the router is not sending the trailing "#" as shown below by debug vtsp.

*Mar 2 01:07:04.887: %SYS-5-CONFIG_I: Configured from console by console

*Mar 2 01:08:21.011: %SYS-5-CONFIG_I: Configured from console by vty0 (15.17.12

3.116)

*Mar 2 01:11:01.446: vtsp_do_call_setup_req

*Mar 2 01:11:01.446: vtsp_allocate_cdb,cdb 0x81ED2DD0

*Mar 2 01:11:01.446: vtsp_insert_cdb,cdb 0x81ED2DD0

*Mar 2 01:11:01.446: vtsp_do_call_setup_req calling oct3 0x0, called oct3 0x80

*Mar 2 01:11:01.446: vtsp_do_call_setup_req: Call ID=256, guid=8211E56C

*Mar 2 01:11:01.450: digit_strip:1, pcn:*753101, poa:.T

*Mar 2 01:11:01.450: pcn:*753101, poa:.T

*Mar 2 01:11:01.450: Final pcn:*753101, poa:.T, dial_string:*753101

*Mar 2 01:11:01.450: calling oct3 0x0, called oct3 0x80

*Mar 2 01:11:01.450: vtsp:[1/1/0 (262), S_SETUP_REQUEST, E_TSP_PROCEEDING]

Re: destination-pattern with "*" and "#"

It doesn't seem that this would be the behavior according to this document.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a0080080aec.html

One way to work around this issue would be to use the "dial-peer terminator" command to change the terminator character to something other than #. This may not be desirable if you have other variable length dial peers.

Another option is to use a voice translation rule on the dial peer such as:

voice translation-rule 1

rule /^\(*75...\)/ /\1#/

voice translation-profile 1

translate called 1

dial-peer voice 70 pots

destination-pattern *75....#

port 1/1/0

forward-digits all

translation-profile outgoing 1

Brandon

141
Views
0
Helpful
3
Replies