If I may ask, what do you percieve as a problem when caching the report? The devicename stays the same, does it not? Even in a DHCP environment, unless you have very small leases, IP addresses tend to stay the same for devices that are always on. And EM only means a user is logged in at different locations, not the phone IP addresses change. Most apps I can think of depend more on the user, not the actual phone (in case EM is used at least), so I'd try to stick to the EM profile to associate data with a user, not the phone's IP address, whenever possible. And even if you need the IP, there's no preventing you from writing a proxy that sits between the actual EM service and the phone so you always know where a user is logged in, without having to make any EM queries.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...