My company uses a dial-out application called Remoteware by Xcellenet (www.xcellenet.com). This app does not support com port redirection, and we are currently considering implementing call managers to replace our legacy PBX. Are FXS ports on a 6509 the way to go or should I just bypass completely use a channel bank? Advice / experiences would be appreciated. Thanks.
You might consider an Adtran Atlas 550. We used one for a modem application, and when the channels aren't being used, they can be used by the Call Manager. All we did was take the PRI into the Atlas, dropped off 16 analog ports for modems, and then sent the DSX connection back to a DT24+. Much less expensive than running through the FXS.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.