Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started.

New Member

Dial-out not working in PLAR confgured between VG200 & ICS7750

I'm trying configure PLAR between FXO of VG200 and FXS of ICS7750. dialing from PSTN to PHONE works fine but PHONE cannot dial-out to PSTN.

.

PSTN--FXO--VG200--ETHERNET--MRP--FXS--PHONE

.

VG200(12.2.13b)

===============

voice-port 1/0/0

connection plar 4800

!

dial-peer voice 100 voip

destination-pattern 4...

session target ipv4:172.17.0.11

dtmf-relay h245-alphanumeric

!

dial-peer voice 101 pots

preference 1

destination-pattern .

port 1/0/0

.

MRP(12.2.13.ZH2)

================

voice-port 0/0

!

....

!

dial-peer voice 101 pots

destination-pattern 4800

port 0/0

!

dial-peer voice 110 voip

destination-pattern T

session target ipv4:172.17.0.12

dtmf-relay h245-alphanumeric

!

.

If I delete the dial-peer 101 on MRP, successfully dial-out to PSTN even PLAR not working.

.

I tested same configuration between VG200s and it works fine both direction.

.

any idea why it doesn't work in ICS7750 ?

.

Thanks,

  • Other Collaboration Voice and Video Subjects
1 REPLY
New Member

Re: Dial-out not working in PLAR confgured between VG200 & ICS77

I fixed by adding a "clid strip" under the dial-peer of MRP.

.

dial-peer voice 101 pots

destination-pattern 4800

clid strip

port 0/0

97
Views
0
Helpful
1
Replies