Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

dial-peer answer-address

I have CCM site that makes VoIP calls to a CME system.

In order for the CME site to receive calls from CCM, I have to use dial-peers with an answer-address of all the DID's we have.

For example, we have 40xx DID's in CCM and would thus have to have the following dial-peer in CME.

dial-peer voice 306 voip

answer-address 40..

dtmf-relay h245-alphanumeric

no vad

Everytime I get a new DID block for my CCM site, I have to add another dial-peer with answer-address of the new DID block in my CME site. Is there a dial-peer I can configure that says anything from the IP of my CCM server, accept?

1 REPLY

Re: dial-peer answer-address

You could do a incoming called-number . or answer-address . on a single dial-peer,

Also note that your dial-peer has codec g729, so you will need transcoding if calls go into CUE (if one exists)

925
Views
0
Helpful
1
Replies