In IOS 12.2.5 (AS5300), the dial-peer will have these info:
Successful Calls, Failed Calls, Incomplete Calls,
Accepted Calls, Refused Calls. I want to have the percentage of successful calls. However, I'm confused on how to calculate the number of total calls. I thought it was: total call = accepted call, but it's not. Anyone knows how to get that?
Previously in 12.0.7T we had Successful, Failed, Accepted and Refused calls. The calculation is straight-forward:
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4