Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Dial Peer Configuration to Call Manager

Hi,

I have a Call Manager cluster one publisher & one subcriber. My voice gateway is a 1760 router with FXO cards on it. I have configured 2 dial peer voip one pointing to the publisher & one pointing to the subscriber. I have also issued a preference command on the VOIP peers to handle the outage of any one call manager. In case the publisher is down the second VOIP peer is used pointing to the subscriber. This setup is working perfectly fine but the only problem is incase the publisher is down the call routing is taking about 15 seconds. From the logs I can see that the call first tries to use the VOIP peer pointing to the publisher & after that switches over to the VOIP peer pointing to the subscriber. Is there a way to reduce this delay when switching over from one VOIP peer to another.

Thanks in advance

chetan

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: Dial Peer Configuration to Call Manager

Hi,

1) create a voice class

voice class h323 1

h225 timeout tcp establish 3

---------------------------------------

assign this voice class to dial-peers

dial-peer voice 17000 voip

preference 1

!-–– route to primary CM is preferred

destination-pattern XXXX

voice-class h323 1

regards

mehmet

2 REPLIES
Bronze

Re: Dial Peer Configuration to Call Manager

Hi,

1) create a voice class

voice class h323 1

h225 timeout tcp establish 3

---------------------------------------

assign this voice class to dial-peers

dial-peer voice 17000 voip

preference 1

!-–– route to primary CM is preferred

destination-pattern XXXX

voice-class h323 1

regards

mehmet

New Member

Re: Dial Peer Configuration to Call Manager

Thanks a Lot

Regards

Chetan

141
Views
0
Helpful
2
Replies
CreatePlease to create content