Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Dial peer help

I have a Call Manager hooked up to a router which is configured as follows:

voice-port 1/0/0

connection plar 29990

!

voice-port 1/0/1

!

!

dial-peer cor custom

!

!

!

dial-peer voice 1 pots

incoming called-number .

destination-pattern 91..........

direct-inward-dial

port 1/0/0

forward-digits 11

!

dial-peer voice 100 voip

incoming called-number 4570

destination-pattern 2....

session target ipv4:172.16.200.5

dtmf-relay h245-alphanumeric

codec g711ulaw

My IP phone service provider recently told us that we can use 7-digit dialing also, I'd like to do international dialing but not sure how to implement these on the existing dial plan.

Any help will be greatly appreciated.

Thanks,

Mitch

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Dial peer help

Your requirements is similar to the typical north american numbering plan - 7-digit, long distance, international.

A simple setup would be

1. In Callmanager, create a route pattern 9.@ and point it to this gateway. Use the discard instructions "Pre Dot"

2. In the gateway, create a dial-peer as follows

dial-peer voice 1 pots

incoming called-number .

destination-pattern .T

direct-inward-dial

port 1/0/0

3. You would need an additional route pattern and dial-peer for 911 calls

Regards,

Anup

1 REPLY
Silver

Re: Dial peer help

Your requirements is similar to the typical north american numbering plan - 7-digit, long distance, international.

A simple setup would be

1. In Callmanager, create a route pattern 9.@ and point it to this gateway. Use the discard instructions "Pre Dot"

2. In the gateway, create a dial-peer as follows

dial-peer voice 1 pots

incoming called-number .

destination-pattern .T

direct-inward-dial

port 1/0/0

3. You would need an additional route pattern and dial-peer for 911 calls

Regards,

Anup

254
Views
0
Helpful
1
Replies