Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

dial-peer issue

Hi,

Beacause of customer requirements dial-peer match incoming and outgoing calls. All works fine, however for one BRI CLID is set and for another CLIR (clid restrict) is set. CLIR clears also CLID also for incoming calls.

How to differentiate dial-peers for incoming and outgoing calls?

9 REPLIES
Hall of Fame Super Gold

Re: dial-peer issue

Please explain what you want to do in other words, because what you wrote above cannot be understood.

New Member

Re: dial-peer issue

OK

I am sorry for unclear info.

I want clid restrict for outgoing calls and no clid restrict of incoming calls.

regards

Hall of Fame Super Gold

Re: dial-peer issue

Do you have CM, CME or what else do you have ?

New Member

Re: dial-peer issue

CM + GW with H.323

Hall of Fame Super Gold

Re: dial-peer issue

New Member

Re: dial-peer issue

I am not going to do this on CCM but on GW.

Hall of Fame Super Gold

Re: dial-peer issue

Choose a prefix to hide CLID, like *67*

Make sure CM sends calls with that prefix to GW.

Configure a pots DP with that destination-pattern, bri port or trunk-group, and "clid restrict".

That should be enough.

New Member

Re: dial-peer issue

I need this to do only on GW, so you idea is not an option for me.

thanks.

Hall of Fame Super Gold

Re: dial-peer issue

On GW I'm talking about.

375
Views
0
Helpful
9
Replies