Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Dial-peer Preference

Problem with two seperate dial-peers. The config is below for the two. Essentially what happens is the lower priority dial-peer is chosen over the higher for some reason. when we shut down dial-peer 1780 the router then used dial-peer 1781.

++++++++++++++++++++++++++++++++

dial-peer voice 1780 pots

trunkgroup pstn

corlist outgoing diallongdistance

description outbound long distance dialing

preference 2

destination-pattern 91[2-9]..[2-9]......

progress_ind alert enable 8

progress_ind progress enable 8

progress_ind connect enable 8

prefix 1

!

dial-peer voice 1781 pots

corlist outgoing diallongdistance

description outbound long distance dialing

preference 1

destination-pattern 91[2-9]..[2-9]......

progress_ind alert enable 8

progress_ind progress enable 8

progress_ind connect enable 8

port 0/0/0:0

prefix 1

!

+++++++++++++++++++++++++++++++++++

dial-peer 1780 uses FXOs to get outbound adn 1781 uses a CAS port. Any questions or ideas. version of code is 12.4.3. router is a 2821.

2 REPLIES
Bronze

Re: Dial-peer Preference

I wonder if it has anything to do with your trunkgroup command? if you lock it down to one fxo port, what happens?

Re: Dial-peer Preference

Strangly we performed another test with the dial-peers where we changed the order and when we put the 1781 first in the configuation. When we did this the 1781/cas was used first. This shows that the preference isn't working for some reason. hint, hint: bug possibly.

142
Views
0
Helpful
2
Replies
CreatePlease to create content