When configuring dial peers for using H323 GW's to 2 CallManagers, you can send incoming calls to the 2 CM's using preference and h225 timeout tcp establish in the H323 voice class. I want to do this also with 2 SIP PBX's. I want to create 2 dial peers with the same dest pattern to point to 2 different PBX's, using SIP. Is preference enough? Do I need to configure some timeout mechanism like with H323?
No, There is no eq to H224 timeout in SIP. You just do pref and that should take care of it. One thing you can do if you want to load balance is to use a DNS server to load balance and session target dns:blah.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...