Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Dial Tone On Bri Voice ports

How can I make a Bri voice port to present a dial tone when it aswer a call????

  • Other Collaboration Voice and Video Subjects
2 REPLIES

Re: Dial Tone On Bri Voice ports

Not knowing exactly what you want to do, it's difficult to say, however I would begin with you can't.

Quite simply you have to specify a destination for the incoming call which must valid.

There are 2 options,

1) point the call at an IVR and configure the IVR with a message which is recorded dial tone. You then need to configure the IVR with a menu that responds to the possible destinations dialed by the caller.

2) do not configure Direct-inward-dial on the port on the router, and do not specify a destination in a dial-peer. I know this will give you dial tone but I'm not sure where you can then dial on to.

Paul

Silver

Re: Dial Tone On Bri Voice ports

You need to configure an inbound a dial peer without direct inward dial. By default the router will present dialtone on the isdn calls.

Then you can call anywhere the router has a dialplan for, i.e a matching dial peer.

Taimoor

194
Views
0
Helpful
2
Replies
This widget could not be displayed.