Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Dial tone problem/Question

I have the following Senerio (see jpeg.) When I call from one extention to the other over my lab PSTN I Have to dial the number twice. (IE. I will dial ext 2000 from ext 1005 and get dialtone then if I dial 2000 again it will ring through.) Any idea why I have to dial the number twice to complete a phone call? Is there some setting in CM that I might be missing?

2 REPLIES
Hall of Fame Super Silver

Re: Dial tone problem/Question

Add direct-inward-dial command on your incoming pots dial-peer.

HTH, please rate all posts!

Chris

New Member

Re: Dial tone problem/Question

Would that be the dial peers on the Gatways or the PSTN router?

160
Views
0
Helpful
2
Replies
CreatePlease to create content