Is there a way to code a delay into the dial string of the Dial URI? I need to add a 1-2 second delay in two places in the dial string. I have tried commas in the example below (old school), but that doesn't seem to have any effect.
don't blame you wanting to avoid tapi. how about using the KEY: URI? that way, you can dial the number a key at a time, inserting pauses where you want to. of course, every key will be a separate CiscoIPPhoneExecute, but at least you'll be able to get the delay you need (and probably more!)
Sending a DIAL: to a phone causes it to dial the number sent. EDITDIAL pops up a dialog on the phone that allows the user to edit the number before dialing it.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...