I have 4 callmanagers connected to 1 router with 4 BRI ports.
In order to have the phones that are registered to a particular callmanager use a certain BRI port I added a prefix in the Route Pattern (for example 11 for the first Callmanager) which matches the destination-pattern on the dial-peer (dial-peer voice 1 110.T).
This works fine, but.....
when a phone user dials 0030....etc. the displayed number on the phone is 11030...). I want the displayed number to be the same as the number the user has dialed, NOT the number the router uses to make a match with a dial-peer.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...