Ok. I was reading the Networking Document and had a question about dialing domains in relationn to Exchange 5.5 sites. I am pretty sure you can do this based on the doc. Just would like to run in by you to make sure.
Customer has about 25 diffrent Exchange 5.5 sites. There are two unity servers (Both are in diffrent Exchange 5.5 sites). Can you network these unity servers together via dialing doamins even though they are in diffrent Exchange sites?
Re: Dialing Domains and Several Exchange 5.5 Sites
Yes you can.
Ex55 will replicate the user and location data across the org here and the networking monitor on Unity will see these users from the other site come across (eventually) and add them to the global locations and global subscribers table - this is what Unity uses when it's doing lookups across multiple boxes in the same dialing domain.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.