Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Dialing out a Gateway with BRI gives ISDN Disconnect Cause = 0x82E4

Hello,

I'm having a IOS H323 gateway configured and when I try to place a call to the PSTN using a BRI interface, I get a the following ISDN disconnect cause:

Cause i = 0x82E404 - Invalid information element contents

The bearer cap looks also wrong: 0x8090A2 (G.711 u-Law Speech) instead of 0x8090A3 (G.711 A-law). The gateway is a VG200 with IOS 12.2(13). Can anyone tell me what is going wrong?

--- config gateway ---------

!

interface BRI1/0

description **** PSTN 0402300496 *****

no ip address

isdn switch-type basic-net3

isdn overlap-receiving

isdn incoming-voice voice

isdn send-alerting

!

voice-port 1/0/0

cptone NL

bearer-cap Speech

!

!

dial-peer voice 1 pots

preference 1

destination-pattern 0T

direct-inward-dial

port 1/0/0

!

dial-peer voice 3 voip

preference 1

destination-pattern T

voice-class h323 1

session target ipv4:10.1.1.1

dtmf-relay h245-alphanumeric

codec g711alaw

1 REPLY
New Member

Re: Dialing out a Gateway with BRI gives ISDN Disconnect Cause =

I Already found it myself. This is the command needed to change the bearer cap:

voice-port 1/0/0

compand-type a-law

It wil change the bearer cap from 0x8090A2 (G.711 u-Law Speech) to 0x8090A3 (G.711 A-law). The connection to PSTN is fully operational now. Thanks.

787
Views
0
Helpful
1
Replies
CreatePlease login to create content