Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Dialogic Generation 2 Service Provider

Hello

I have just installed a fresh install of 2.4.6 161 on W2K with 2 x D41EPCI Dialogic boards and I am unable to see the ports under Unity?

The boards will install fine and the services will start but we I go into telephony providers I am unable to configure the Dialogic Gen 2 SP or add add or remove it?

Any help would be great

Thanks

Andy

  • Other Collaboration Voice and Video Subjects
1 REPLY
New Member

Re: Dialogic Generation 2 Service Provider

Do you have an SC BUS connector cable running between the two voice boards? If not, you can only configure one voice board (remove the second) until you can connect the two with the ribbon cable.

114
Views
0
Helpful
1
Replies
This widget could not be displayed.