Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

DID and FXO

Hi,

I installed the FXO card on CME router. Is that possible to enable DID on FXO card ? so if someone call particular number then it will be forwarded to the cisco ip phone. I have done this on E1 card, but I am not sure about FXO.

many thanks for any feedback

thanks

santo

4 REPLIES
Community Member

Re: DID and FXO

No, but Cisco does makes a card for analog DID.

It is VIC-2DID.

Community Member

Re: DID and FXO

Hi,

What kind of line should I connect to VIC-2DID ? Is it similiar like FXO lines ? I heard that it's only for incoming call, not for outgoing call. is that true ? My requirements are actually I need DID and outgoing call on the same lines. Do you ever know about VIC2-2DID ? what is the difference with VIC-2DID ?

thanks alot

-santo-

Community Member

Re: DID and FXO

You would get analog DID lines from the carrier. And yes, it is true , you cannot use the DID lines for outbound calling.

If you to get DID and inbound/outbound calling is use ISDN PRI.

Community Member

Re: DID and FXO

How many phone numbers are associated with each analog line? If there is only one number per line you can simulate DID using the plar command in the dial peer. I have done this for a small CME implementation and it worked well.

183
Views
0
Helpful
4
Replies
CreatePlease to create content