Hello, trying to solve a problem with cme 3.3 on 2821 platforms, the problem is that direct inward dial on a 4 bri trunk is used.
For me the concept of 4 bri trunks means that after the first two B channels of the first BRI are occupied the first B channel on the second bri can receive the 3rd incoming call and so on. All four BRI's are associated to one public number.
PROBLEM: The 3rd incoming call doesn't get in.
The trunk works well, when I use "connection plar" more than two calls can get in at the same time.
NOTE: My idea was to use a sequential ephone-hunt, here's the config:
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.